Radwin 5000 HPMP User Manual page 351

Trap Parameters
Table C-3: MIB Traps (Sheet 4 of 6)
Name
cbwMismatch
gpsNotSynchronized
pdTooHighDueCbwLimitations
hbsEncryptionAlarm
hbsEhServiceClosedToHsu
hbsUnsynchronizedHsuAlarm
hbsInactiveHbsAlarm
incompatibleHsu
hsuUnsupportedBeacon
tdmServiceClear
ethServiceOpened
encryptionClear
changeLinkPasswordClear
externalAlarmInPort1Clear
externalAlarmInPort2Clear
lanPort1Clear
lanPort2Clear
mngPortClear
externalAlarmInPort3Clear
externalAlarmInPort4Clear
swVersionsMatchFullCompatibilityClear
swVersionsMatchRestrictedCompatibilityClear
RADWIN 5000 HPMP User Manual
ID Severity Description
130 major Indicates that a Channel Bandwidth mismatch was detected.Contains two
parameters: 1 - Description: Channel Bandwidth Mismatch: one side is
%n0 MHz and the other is %n1 MHz. %n0 is the local Channel
Bandwidth value in MHz. %n1 is the remoet Channel Bandwidth value in
MHz.
131 major Indicates that the GPS is not synchronized with satellites. Pulses are
self generated.
132 major Indicates that link cannot be established because link range is too large
for channel bandwidth.
133 major Indicates an encryption key mismatch. Contains a single parameter
which is its description including the HSU's name
134 major Indicates an encryption key mismatch. Contains a single parameter
which is its description including the HSU's name
135 warning
Indicates a registered HSU lost synchronization.
136 major Indicates HBS is InActive.
137 critical
Indicates that the HSU is not compatible to HBS. Contains a single
parameter which is its description: 1 - Description: Incompatible ODUs.
138 warning
Indicates an unsupported beacon has arrived at HSU
200 major Indicates that TDM Service fault is cleared. Contains a single parameter
which is its description: 1 - Description: TDM Service - Normal.
201 normal Indicates that Ethernet Service has been opened. Contains a single
parameter which is its description: 1 - Description: Ethernet Service has
been opened.
203 normal Indicates that encryption is OK. Contains a single parameter which is its
description: 1 - Description: Encryption Status - Normal.
204 normal Indicates that the Link Password was changed successfully. Contains a
single parameter which is its description: 1 - Description: Link Password
has been changed at/on: %s. %s - Is the Local Site name or Remote
Site name or both sides of the Link.
205 normal This Trap is sent every time an External Alarm Input fault of port # 1 is
cleared. Contains a single parameter which is its description: 1 -
Description: External Alarm 1 - <User Text> - Alarm Cleared.
206 normal This Trap is sent every time an External Alarm Input fault of port # 2 is
cleared. Contains a single parameter which is its description: 1 -
Description: External Alarm 2 - <User Text> - Alarm Cleared.
209 normal Indicates the LAN port 1 status changed to connected. Contains two
parameters: 1 - Description: LAN port 1 status changed to connected -
%s 2 - %s Is the Eth. mode (speed & duplex)
210 normal Indicates the LAN port 2 status changed to connected. Contains two
parameters: 1 - Description: LAN port 2 status changed to connected -
%s. 2 - %s Is the Eth. mode (speed & duplex).
211 normal Indicates the management port status changed to connected. Contains
two parameters: 1 - Description: Management port status changed to
connected - %s 2 - %s Is the Eth. mode (speed & duplex)
212 normal This Trap is sent every time an External Alarm Input fault of port # 3 is
cleared. Contains a single parameter which is its description: 1 -
Description: External Alarm 3 - <User Text> - Alarm Cleared.
213 normal This Trap is sent every time an External Alarm Input fault of port # 4 is
cleared. Contains a single parameter which is its description: 1 -
Description: External Alarm 4 - <User Text> - Alarm Cleared.
214 normal The trap is sent if SW versions match. Contains a single parameter
which is its description: 1 - Description: Software Versions compatible
215 normal The trap is sent if SW versions match and link functionality is not
restricted. Contains a single parameter which is its description: 1 -
Description: Software Versions compatible
Release 3.3.30
Appendix C
C-33