Radwin 5000 HPMP User Manual page 165

Telnet Access to the HBS
Supported HBS Telnet commands are shown in
Table 6-1: HBS Telnet - Display Commands
Command
display inventory
display management
display link <param:all,reg,unreg>
display ethernet
display ethernet_errors
display ntp
display PM <interface:AIR,LAN1>
<interval:current,day,month>
display bands
Table 6-2: HBS Telnet - Set Immediate Commands
Command
set ip <ipaddr> <subnetMask> <gateway>
set trap <index:1-10> <ipaddr> <port:0-
65535>
set readpw <oldpasswd> <passwd>
set writepw <oldpasswd> <passwd>
set trappw <oldpasswd> <passwd>
set tpc<power:Value between minimal Tx power,
and maximal Tx power>
set name <new name>
set location <new location>
set contact <new contact>
set ethernet <port:LAN1>
<mode:AUTO,10H,10F,100H,100F,DISABLE>
reboot
help
Table 6-3: HBS Telnet - Set Commands requiring Reset
Command
set secId <SectorID>
RADWIN 5000 HPMP User Manual
Table 6-1 to
Explanation
Displays ODU product name, Name, Location, hardware and software
revisions, uptime, MAC address.
Displays IP, subnet, Gateway, Traps table
Displays all static details about the sector or HSU
Displays Port table (State, Status and action)
Displays Cable statistics
Displays Time, Server and Offset
Shows the performance monitor tables for each interface according to
user defined monitoring intervals
Displays available bands
Explanation
Set the ODU IP address, subnet mask and gateway. The user must reset
the ODU after the command completion
Set a specific trap from the traps table (e.g. set trap 3 192.168..101 162)
Set the read access password (Read Community)
Set the read-write access password (Read-Write Community)
Set the trap Community string
Set the ODU Tx Power. If a wrong value is entered, both min and max
values shall be displayed in the error reply
Set the name of the link
Set the name of the location
Set the name of the site manager
Set the mode and speed of the Ethernet port
Resets the ODU. The user is warned that the command will reset the
ODU. A new Telnet session to the ODU may be opened after the reset is
complete.
Displays the available commands
Explanation
Set new sector ID - Reset required.
Release 3.3.30
Chapter 6
Table 6-3.
6-45