Radwin Manager Traps - Radwin 5000 HPMP User Manual

RADWIN Manager Traps

Table C-3: MIB Traps (Sheet 6 of 6)
Name
switchCBW
changeRatio
lanPortClear
poePortClear
poePowerConsumptionClear
incompatibleHbsHsu
mobilityLinkOff
RADWIN Manager Traps
The RADWIN Manager application issues traps to indicate various events. These traps are
shown in the RADWIN Managerr Events Log.
A list of Trap Messages as displayed by the RADWIN Manager is shown in
RADWIN 5000 HPMP User Manual
ID Severity Description
241 normal Switching Channel Bandwidth.
242 normal HBS Tx ratio has changed.
243 normal Indicates the LAN port status changed to connected.
Contains two parameters:
1 - Description: LAN port status changed to connected - %s
2 - %s Is the Eth. mode (speed & duplex)
244 normal Indicates the POE port status changed to connected.
Contains two parameters:
1 - Description: POE port status changed to connected - %s
2 - %s Is the Eth. mode (speed & duplex)
245 normal Indicates the POE power consumption is valid.
Contains two parameters:
1 - Description: POE consumption within limits. port is opened.
2 - %s Is the Eth. mode (speed & duplex)
246 normal Incompatible HBS/HSU software versions - no service.
247 normal Mobility - Link cannot be established due to:
1 - The HBS does not support Mobility
2 - Lack of resources in the HBS for HSU level
Release 3.3.30
Appendix C
Table 9-4.
C-35