Radwin 5000 HPMP User Manual page 338

Private MIB Parameters
Table C-2: Private MIB Parameters (Sheet 16 of 24)
Name
winlink1000IduAdmVlanDefaultPortVIDs
winlink1000IduAdmVlanLan1UntaggedVIDs
winlink1000IduAdmVlanLan2UntaggedVIDs
winlink1000IduAdmVlanSfpUntaggedVIDs
winlink1000IduAdmVlanLan1FilteredVIDs
winlink1000IduAdmVlanLan2FilteredVIDs
winlink1000IduAdmVlanSfpFilteredVIDs
winlink1000IduAdmPortsConnection
winlink1000IduAdmVlanMode
winlink1000IduAdmVlanMembershipVIDs
winlink1000IduAdmVlanMembershipPortsCode
winlink1000IduAdmVlanMembershipUntaggedH
andle
winlink1000IduAdmVlanMembershipTagUntagg
ed
winlink1000IduSrvDesiredTrunks
winlink1000IduSrvServices
winlink1000IduSrvActiveTrunks
winlink1000IduSrvAvailableTrunks
winlink1000IduSrvPossibleServicesTable
winlink1000IduSrvPossibleServicesEntry
winlink1000IduSrvPossibleServicesIndex
winlink1000IduSrvPossibleTdmServices
winlink1000IduSrvPossibleEthServices
winlink1000IduSrvRemainingRate
RADWIN 5000 HPMP User Manual
OID
Release 3.3.30
Type Description
RW VLAN tag/untag default VLAN ids for each port -
Right most digit is Vlan priority (0-6) other digits
compose Vlan Id (1-4094)
RW VLAN untagged VIDs for LAN1 port
RW VLAN untagged VIDs for LAN2 port
RW VLAN untagged VIDs for Sfp port
RW VLAN filtered VIDs for LAN1 port
RW VLAN filtered VIDs for LAN2 port
RW VLAN filtered VIDs for Sfp port
RW IDU ports connection bitmap. bit 0 - LAN1-LAN2
bit 1 - SFP-LAN1
0 - ports are disconnected.
connected.
RW Local IDU Vlan Mode.
RW VLAN Membership VLAN IDs list.
RW VLAN Membership ports code. Each value
represent the relation (bitmap)
suitable VID to the IDU ports. bit 0 - LAN1 bit 1 -
LAN2
appropriate VID
appropriate VID
RW VLAN Membership Untagged frames handling.
The 3 values representing LAN1 LAN2 and SFP
accordingly.
are: 1 - Discard
RW VLAN Membership Untagged frames tagging. The
3 values representing LAN1 LAN2 and SFP
accordingly.
represent the tagging value which is built of:
VLAN ID & VLAN Priority.
RW Required trunks bitmap.
possible trunks that can be configured may vary
based on the IDU hardware
selected air interface rate and the range of the
installation.
enables the user to select only available
configurations. A change is effective immediately if
applied to a master unit and the link is in service
mode.
RO This parameter is reserved to the Manager
application provided with the product.
RO A bitmap describing the currently open TDM trunks.
RO A bitmap describing the number of TDM trunks that
can be opened in the current configuration.
values take into account the IDU hardware
configuration the air rate and the installation range.
N/A IDU Possible Services table.
N/A IDU Services table entry. INDEX {
winlink1000IduSrvPossibleServicesIndex }
RO Table index Rate index of the air interface.
RO Deprecated parameter. A bitmap describing the
TDM trunks that can be opened in the
corresponding Air Rate.
RO Deprecated parameter. This parameter describes
if the Ethernet Service can be opened in the
corresponding Air Rate. The valid values are:
disabled (0) enabled (1).
RO Current Ethernet bandwidth in bps per air rate.
Appendix C
bit 2 - SFP-LAN2
1 - ports are
Between the
bit 2 - SFP bit value 0 - not member of
bit value 1 - member of
For each port the optional values
2 - Tag 3 - Leave Unmodified
The value on each port entry
Note that the number of
configuration the
The provided Manager application
C-20
bit values:
The