Radwin 5000 HPMP User Manual page 128

Management
3. Enter a Priority number between 0 and 7.
The VLAN priority is used for the traffic sent from the ODU to the managing com-
puter.
4. Change the VLAN ID and Priority of the managing computer NIC to be the same as
those of steps 2 and 3 respectively.
5. Click Apply or OK.
Lost or forgotten VLAN ID
If the VLAN ID is forgotten or there is no VLAN traffic connected to the ODU, then reset the
relevant ODU.
During the first two minutes of connection, the ODU uses management packets both with and
without VLAN. You may use this period to reconfigure the VLAN ID and priority.
Supported Protocols
For a sector managed as part of a network, direct access to a HBS/HSU using Telnet is consid-
ered to be a security breach. Telnet access may be enabled or disabled by clicking the Proto-
col tab and enabling/disabling Telnet access using the Telnet check-box. Similar
considerations apply to access via the Web Interface.
• For further details about Telnet access see
• For further details about the Web Interface, see
SNMP access is on by default for RADWIN 5000 HPMP and cannot be
disabled.
Note
Telnet and Web Interface access modes when available, are site specific. If for example, you
want Telnet access from specific sector members, you should enable it for these sites and dis-
able it elsewhere.
If Telnet or Web Interface access mode poses a general security risk, you
must disable them for each sector member separately.
Note
RADWIN 5000 HPMP User Manual
page 6-44.
Chapter
Release 3.3.30
Chapter 6
21.
6-8