Operation
Instrument Controls Menu
3-36
Model 43i Trace Level-Enhanced Instruction Manual
The IP Address screen is used to edit the IP address. The IP address can
IP Address
only be changed when DHCP is OFF. For more information on DHCP,
see "Use DHCP" above.
In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > IP Address.
Netmask
The Netmask screen is used to edit the netmask. The netmask is used to
determine the subnet for which the instrument can directly communicate
to other devices on. The netmask can only be changed when DHCP is
OFF. For more information on DHCP, see "Use DHCP" in this chapter.
In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > Netmask.
Gateway
The Default Gateway screen is used to edit the gateway address. The
default gateway can only be changed when DHCP is OFF. For more
information on DHCP, see "Use DHCP" in this chapter. Any traffic to
addresses that are not on the local subnet will be routed through this
address.
In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > Gateway.
IP ADDRESS:
CURRENT: 192.168.1.200
SET TO:
192.168.001.015
MOVE CURSOR
CHANGE VALUE
SAVE
RANGE
AVG
NETMASK:
CURRENT: 255.255.255.0
SET TO:
255.255.255.000
MOVE CURSOR
CHANGE VALUE
SAVE
RANGE
AVG
DIAGS ALARM
DIAGS ALARM
Thermo Fisher Scientific