TCP/IP Settings
Thermo Fisher Scientific
ANALOG INPUTS:
>NONE
The TCP/IP Settings menu is used for defining parameters that are
required for Ethernet communications.
Note The instrument power must be cycled after any of these parameters
have been changed for the change to take effect.
In the Main Menu, choose Instrument Controls > Communication
●
Settings > TCP/IP Settings.
TCP/IP SETTINGS:
>USE DHCP
Use DHCP
The Use DHCP screen is used to specify whether to use Dynamic Host
Configuration Protocol (DHCP) or not. When DHCP is enabled, the
network dynamically provides an IP address for the instrument.
In the Main Menu, choose Instrument Controls > Communication
●
Settings > TCP/IP Settings > Use DCHP.
DHCP:
CYCLE POWER TO CHANGE DHCP
ANALOG IN 1
ANALOG IN 2
ANALOG IN 3
ANALOG IN 4
RANGE
AVG
DIAGS ALARM
IP ADDR
10.209.43.237
NETMASK
255.255.254.0
GATEWAY
10.209.42.1
HOST NAME
RANGE
AVG
DIAGS ALARM
NTP SVR
10.209.43.237
CURRENTLY:
SET TO:
TOGGLE VALUE
RANGE
AVG
DIAGS ALARM
Instrument Controls Menu
▲
OFF
iSeries
OFF
ON ?
Model 42i Instruction Manual
Operation
3-41