Thermo Fisher Scientific
Alarms
The Alarms status screen allows the user to select the alarm status for the
selected relay output. The selected item is shown by "<--" after it.
In the Main Menu, choose Instrument Controls > I/O Configuration >
Output Relay Settings > Select Relay > Instrument State > Alarms.
Note The I/O BD STATUS alarm is only present if the I/O expansion
board is installed. ZERO CHK/CAL and SPAN CHK/CAL are only
present if autozero/span check is enabled.
The Non-Alarm status screen allows the user to select the non-alarm status
Non-Alarm
for the selected relay output. The selected item is shown by "<--" after it.
In the Main Menu, choose Instrument Controls > I/O Configuration >
Output Relay Settings > Relay 1-10 > Instrument State > Non-Alarm.
CHOOSE SIGNAL TYPE:
>ALARMS
NON-ALARM
RANGE
AVG
ALARM STATUS ITEMS:
>NONE
GEN ALARM
SO2 CONC MAX
SO2 CONC MIN
INT TEMP
CHAMB TEMP
PRESSURE
RANGE
AVG
SAMPLE FLOW
FLASH REF
FLASH VOLTS
MB STATUS
MIB STATUS
I/O BD STATUS
CONC ALARM
ZERO CHK/CAL
SPAN CHK/CAL
Model 43i Trace Level-Enhanced Instruction Manual
DIAGS ALARM
▲
<--
DIAGS ALARM
Operation
Instrument Controls Menu
3-39