Advertisement
Service Menu
Flash Voltage
Adjustment
Thermo Fisher Scientific
The Service menu appears only when the instrument is in the service mode.
To put the instrument into the service mode:
In the Main Menu, choose Instrument Controls > Service Mode.
Advanced diagnostic functions are included in the service mode.
Meaningful data should not be collected when the instrument is in the
service mode. In dual or auto range modes, "HI" or "LO" multi-point
calibration is displayed to indicate the calibration of the high or low
concentrations.
In the Main Menu, choose Service.
SERVICE:
>FLASH VOLTAGE ADJUSTMENT
INITIAL FLASH REFERENCE
PMT SUPPLY SETTINGS
RANGE MODE SELECT
PRESSURE CALIBRATION
FLOW CALIBRATION
INPUT BOARD TEST
RANGE
TEMPERATURE CALIBRATION
ANALOG OUT CALIBRATION
ANALOG INPUT CALIBRATION
PERM OVEN SETTINGS
DILUTION RATIO
DISPLAY PIXEL TEST
RESTORE USER DEFAULTS
The Flash Voltage Adjustment screen allows the user to manually adjust
the flasher supply voltage. The flash voltage adjustment screen is visible
only when the instrument is in service mode. For more information on the
service mode, see "Service Mode" earlier in this chapter.
Note This adjustment should only be performed by an instrument service
technician.
▲
In the Main Menu, choose Service > Flash Voltage Adjustment.
AVG
DIAGS ALARM
Model 43i Trace Level-Enhanced Instruction Manual
Operation
Service Menu
3-65
Advertisement
Troubleshooting
