Advertisement
RS-232/RS-485 SELECTION:
XXXXXX** WARNING
DISCONNECT THE
CABLES BEFORE CHANGING
THE
RANGE
AVG
TCP/IP Settings
Thermo Fisher Scientific
In the Main Menu, choose Instrument Controls > Communication
Settings > RS-232/RS-485 Selection.
**XXXXXXX
SERIALX X
SELECTION!XXXXXX
TO CONTINUE
DIAGS ALARM
The TCP/IP Settings menu is used for defining TCP/IP settings.
Note The instrument power must be cycled after this parameter has been
changed for the change to take effect.
In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings.
The Use DHCP screen is used to specify whether to use DHCP or not.
Use DHCP
When DHCP is enabled, the network dynamically provides an IP address
for the instrument. The instrument's power must be cycled for a change to
this parameter to take affect.
In the Main Menu, choose Instrument Controls > Communication
Settings > TCP/IP Settings > Use DCHP.
RS-232/RS-485 SELECTION:
CURRENTLY:
X
MAKE SURE THAT THE
IS OFF: PRESS
RANGE
TCP/IP SETTINGS:
>USE DHCP
IP ADDRESS
192.168.1.200
NETMASK
255.255.255.0
GATEWAY
HOST NAME
RANGE
AVG
DHCP:
CURRENTLY:
SET TO:
TOGGLE VALUE
CYCLE POWER TO CHANGE DHCP
RANGE
AVG
Model 43i Trace Level-Enhanced Instruction Manual
SET TO:
TO CONFIRM
TOGGLE VALUE
AVG
DIAGS ALARM
▲
OFF
192.168.1.1
iSeries
DIAGS ALARM
OFF
ON ?
DIAGS ALARM
Operation
Instrument Controls Menu
RS-232
RS-485 ?
CABLEXX
3-35
Advertisement
Troubleshooting
