Table B-1. Error Response Messages; Table B-1. C-Link Protocol Commands - Thermo Scientific 42i Instruction Manual

Convert Concentration
Formats
Commands List
Thermo Fisher Scientific
Table B–1. Error Response Messages
Command Response
bad cmd
too high
too low
invalid string
data not valid
can't, wrong settings
can't, mode is service
The "save" and "set save params" commands (duplicated for backward
compatibility) store parameters in FLASH memory. It is important that
this command be sent each time instrument parameters are changed. If
changes are not saved, they will be lost in the event of a power failure.
Convert concentration formats from xxxxE+yy to x.xxxE+yy. The iSeries
uses more standard script than the C-Series by placing only one digit to the
left of the decimal.
Table B–1 lists the 42 i C-Link protocol commands. The interface will
respond to the command strings outlined below.
Table B–1. C-Link Protocol Commands
Command Description
1 Simulates pressing soft key 1 pushbutton
2 Simulates pressing soft key 2 pushbutton
3 Simulates pressing soft key 3 pushbutton
4 Simulates pressing soft key 4 pushbutton
addr dns Reports/sets domain name server address for Ethernet port
addr gw Reports/sets default gateway address for Ethernet port
addr ip Reports/sets IP address for Ethernet port
addr nm Reports/sets netmask address for Ethernet port
addr ntp Reports the IP address for network time protocol server
alarm chamber Reports/sets chamber temperature alarm maximum value
temp max
Description
Command is not recognized
Supplied value is higher than the upper limit
Supplied value is lower than the lower limit
Supplied string invalid (typically because a letter was detected
when the value should be numeric)
Supplied value is not acceptable for entered command
Command not allowed for current measurement mode
Command not allowed while instrument is in service mode
C-Link Protocol Commands
Commands
Page
B-33
B-33
B-33
B-33
B-43
B-43
B-43
B-44
B-44
B-14
Model 42i Instruction Manual B-3