Digisol DG-GS4826S Management Manual page 1156

C 47 | IP Interface Commands
HAPTER
IPv6 to IPv4 Tunnels
Table 159: IPv6 to IPv4 Tunnelling Commands (Continued)
Command Function
tunnel mode ipv6ip Configures the tunnel mode to manual configuration
or 6-to-4 automatic tunneling
tunnel source vlan Sets the VLAN to which a tunnel source is assigned
tunnel ttl Configures the TTL value in the IPv4 header of a
packet used for tunneling IPv6 traffic
show ipv6 tunnel Displays the status and configuration settings for all
IPv6 over IPv4 tunnels
* The tunnel destination only applies to manually configured tunneling (RFC 2893).
C U
OMMAND SAGE
To create a manually configured or automatically configured tunnel, follow
these steps:
1.
Configure a VLAN with the
2.
Assign the ports which will use this VLAN for local services, and those
which will form the entry point for the IPv6 over IPv4 tunnel (using the
switchport allowed vlan
3.
Assign an IPv4 address to the VLAN to serve as the source (or local end
point) of the tunnel using the
4. Create an IPv6 over IPv4 tunnel using the
5. Set the tunnel mode to "configured" for host-to-router or router-to-
router connections, or "6to4" for router-to-host or host-to-host
connections using the
6. For "configured" tunnel mode, specify the IPv4 address of the far end of
the tunnel using the
7. Bind the tunnel to a VLAN with the
8. Assign an IPv6 global unicast address to the tunnel using the
address command.
9.
Then check your configuration settings using the
command, and the interface status of the tunnel using the
interface or show ip interface brief
– 1156 –
vlan command.
command.
ip address command.
interface tunnel
tunnel mode ipv6ip command.
tunnel destination command.
tunnel source vlan
command.
Mode
IC (tunnel)
IC (tunnel)
IC (tunnel)
PE
command.
command.
ipv6
show ipv6 tunnel
show ip