Digisol DG-GS4826S Management Manual page 1154

C 47 | IP Interface Commands
HAPTER
IPv6 Interface
show ipv6
neighbors
E
XAMPLE
The following deletes all dynamic entries in the IPv6 neighbor cache:
Console#clear ipv6 neighbors
Console#
This command displays information in the IPv6 neighbor discovery cache.
S
YNTAX
show ipv6 neighbors [vlan vlan-id | ipv6-address]
vlan-id - VLAN ID (Range: 1-4093)
ipv6-address - The IPv6 address of a neighbor device. You can
specify either a link-local or global unicast address formatted
according to RFC 2373 "IPv6 Addressing Architecture," using 8
colon-separated 16-bit hexadecimal values. One double colon may
be used in the address to indicate the appropriate number of zeros
required to fill the undefined fields.
D S
EFAULT ETTING
All IPv6 neighbor discovery cache entries are displayed.
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
The following shows all known IPv6 neighbors for this switch:
Console#show ipv6 neighbors
State: I1 - Incomplete, I2 - Invalid, R - Reachable, S - Stale, D - Delay,
P1 - Probe, P2 - Permanent, U - Unknown
IPv6 Address
FE80::2E0:CFF:FE9C:CA10
Console#
Table 158: show ipv6 traffic - display description
Field Description
IPv6 Address IPv6 address of neighbor
Age The time since the address was verified as reachable (in minutes). A static
entry is indicated by the value "Permanent."
Link-layer Addr Physical layer MAC address.
– 1154 –
Age Link-layer Addr
4 00-17-7c-9C-CA-10
State VLAN
R 1