Table 59: Time Commands - Edge-Core ECS3510-10PD Management Manual

T
IME
SMTP Minimum Severity Level: 7
SMTP destination email addresses
-----------------------------------------------
ted@this-company.com
SMTP Source Email Address: bill@this-company.com
SMTP Status: Enabled
Console#
The system clock can be dynamically set by polling a set of specified time
servers (NTP or SNTP). Maintaining an accurate time on the switch enables
the system log to record meaningful dates and times for event entries. If
the clock is not set, the switch will only record the time from the factory
default set at the last bootup.

Table 59: Time Commands

Command Function
SNTP Commands
sntp client Accepts time from specified time servers
sntp poll Sets the interval at which the client polls for time
sntp server Specifies one or more time servers
show sntp Shows current SNTP configuration settings
NTP Commands
ntp authenticate Enables authentication for NTP traffic
ntp authentication-key Configures authentication keys
ntp client Enables the NTP client for time updates from specified
servers
ntp server Specifies NTP servers to poll for time updates
show ntp Shows current NTP configuration settings
Manual Configuration Commands
clock summer-time
Configures summer time
(date) clock
clock summer-time Configures summer time<Superscript>* for the
(predefined) switch's internal clock
clock summer-time Configures summer time<Superscript>* for the
(recurring) switch's internal clock
clock timezone Sets the time zone for the switch's internal clock
clock timezone- Sets the time zone for the switch's internal clock using
predefined predefined time zone configurations
calendar set Sets the system date and time
show calendar Displays the current date and time setting
* Daylight savings time.
– 759 –
| System Management Commands
C 20
HAPTER
for the switch's internal
*
Time
Mode
GC
GC
GC
NE, PE
GC
GC
GC
GC
NE, PE
GC
GC
GC
GC
GC
PE
NE, PE