Selecting Security Access Options - Honeywell SmartPAC 2 User Manual

1126800

Selecting Security Access Options

1. In the Initialization menu, select "Security Access."
You will see a display similar to the one below. Yours may look different, depending on
your SmartPAC 2's system configuration. Notice that the factory (default) settings
allow all actions to be performed in both Program and Run modes. See also Table 4 - 13,
above.
SET CNTR PRESET:
ADJUST SENSORS:
DISABLE SENSORS:
USE THE CURSOR KEYS TO MAKE CHOICES.
PRESS THE ENTER KEY TO CHANGE THE MODES.
PRESS F1 TO CHANGE PASSWORDS.
PRESS THE RESET KEY WHEN DONE.
NOTICE
Be sure to check your passwords before changing any security access settings. Record the
passwords in a safe place. See "Changing passwords" later in this chapter to check and
change passwords.
2. To change the security access of an item, use the up and down arrows to highlight the
access information for the item. Press ENTER one or more times until the type of
access you want appears.
For most items, you can choose from the following access levels. Other selections are
shown in Table 4 - 13.
"PROGRAM AND RUN MODES"
"PROGRAM MODE ONLY"
"PASSWORD REQUIRED"
Page 254
SECURITY ACCESS MENU
PROGRAM AND RUN MODES
LOAD TOOL #:
PROGRAM AND RUN MODES
CHANGE COUNT: PROGRAM AND RUN MODES
RESET MODE: PROGRAM AND RUN MODES
PROGRAM AND RUN MODES
PROGRAM AND RUN MODES
ADJUST CAMS: PROGRAM AND RUN MODES
ADJ. PRESS CNTL: PROGRAM AND RUN MODES
ADJUST FEED: PROGRAM AND RUN MODES
LOAD MONITOR: ALLOW RECALC/ADJUST
ADJ. TOOL INFO: PROGRAM AND RUN MODES
INIT PASSWORD: NOT REQUIRED
Figure 4 - 35. Security Access Menu
Chapter 4
SmartPAC 2 with WPC Integration
SmartPAC 2 Initialization Mode