Mounting Options; Installing The Module - Honeywell PRO3200 Installation Manual

Installing the PRO3200 Two-Reader Module

Mounting Options

Relays 1 and 3 are dry-circuit level signal relays typically used to indicate the status of the door lock.
Relays 4 and 5 are general-purpose relay outputs and are not available when the board is
rack-mounted.
Use sufficiently large gauge of wires for the load current to avoid voltage loss.
Mounting Options
This board can be mounted on-edge in the rack-mount enclosure provided by Honeywell or it can be
mounted flat against any surface using standoffs under the mounting holes provided in each of the four
corners of this board.
When this board is rack-mounted, the connectors for two general-purpose inputs, two general-purpose
outputs, and two dedicated inputs are not accessible and should not be used.
The most common reason for mounting a board flat is that it is being installed remotely to be located
near the door(s) being monitored. In this case it will be mounted in its own enclosure creating the need
to monitor cabinet tamper and power fault detection inputs. The two additional general-purpose inputs
and outputs provided allow for the monitoring of extra sensors and control of local horns or other
equipment.

Installing the Module

1. Set Jumpers and DIP switches.
2. Mount this board in the appropriate enclosure - If this board is being mounted in a rack, the
3. Connect the communications and power supply to the circuit boards with the Power Supply
Warning: DO NOT CONNECT THE POWER SUPPLY TO THE AC SOCKET UNTIL ALL WIRING HAS
BEEN INSTALLED AND RECHECKED
4. Connect wiring to the reader interfaces as appropriate.
5. Connect wiring to input sensors or install jumper wire as appropriate.
6. Connect relay output wiring as appropriate.
7. Connect communications wiring to the Intelligent Controller.
12
component side of the board is to your right as you face the rack.
Harness.
.
www.honeywell.com