Select Pm Item Names - Honeywell SmartPAC 2 User Manual

1126800
4. Make sure that you record this number somewhere else. Without it, you cannot change
settings in the PM Monitor. You are now ready to use the PM Monitor. Go to the next
section.

Select PM Item Names

You are now ready to set up PM parameters in Initialization. You can select names for each
preventative maintenance item which adequately describes its function. SmartPAC provides
about 35 names. If there is a function for which you cannot find a suitable name, you can
create a new name using the "Custom" feature (This procedure is explained in step 5 below.)
1. Select "New item" from this display. (You may be asked for a password before getting
to this screen. If so, enter it):
YOUR PRESS NAME
NEW ITEM
USE THE CURSOR KEYS TO MAKE
SELECTION. PRESS ENTER TO
SELECT, RESET WHEN DONE.
2. Next, you will see the following display. You can give the item a name that best
describes its function; so first check the list for a suitable name.
page 446
ITEM
Figure B - 8. PM Monitor Screen
Appendix B
SmartPAC 2 with WPC Integration
PM MONITOR
ALERT EVERY
F6
INIT
SmartPAC Preventive Maintenance
(PM) Monitor