Figure 5 - 30. Select Type Of Cam Timing - Honeywell SmartPAC 2 User Manual

1126800
2. You see a display (similar to Figure 5-23) which includes information about the tool and
cam channel. Notice also the circle diagram on the display.
3. Set the "on angle" and "off angle" using the cursor keys. An arc will move around the
circle diagram as you set the "on" and the "off" angles. These settings are also shown
numerically in the box on the display. See "Cursor keys" under "Using the keyboard" in
Chapter 3 for instructions on how to set the "on" and "off" angles.
4. Press RESET to go back to the display showing the cam channels. You can select
another channel to set.
Here is an example of a display for a part blow-off set at 185° on, 220° off.
arc moves around
"circle diagram"
as you press
cursor keys
to set timing
Figure 5 - 31. Programming Channel 1, "Part blow-off"
page 306

Figure 5 - 30. Select Type of Cam Timing

TOOL NUMBER 1234567
CHAIR BRACKET
0
ON 185
OFF 220
270
DWELL 35
180
Chapter 5
SmartPAC 2 with WPC Integration
CHANNEL 1
UNNAMED
USE THE L/R CURSOR
KEYS TO SET THE
ON ANGLE. USE THE
U/D CURSOR KEYS TO
SET THE OFF ANGLE.
PRESS THE RESET
90
KEY WHEN DONE.
SmartPAC 2 Program Mode
angles when
cam channel
turns on and off