Figure 5 - 15. Advanced Counter Mode - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
PARTS MADE PER EACH STROKE
STROKES TO MAKE EACH PART
2. Highlight the item you want to set. Press ENTER. A box appears on the screen, as
shown below.
PARTS MADE PER EACH STROKE
STROKES TO MAKE EACH PART
Figure 5 - 16. Setting Parts/Stroke or Strokes/Part
3. Use the keypad or cursor keys to change the number of parts/stroke or strokes to make
each part. Press ENTER. Press RESET to return to Counter Mode Selections.
SmartPAC 2 Program Mode
ADVANCED COUNTER MODE SELECTIONS

Figure 5 - 15. Advanced counter mode

ADVANCED COUNTER MODE SELECTIONS
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSOR KEYS TO
INCREASE/DECREASE. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
Chapter 5
1
= 1
= 1
1
= 1
= 1
1
1126800
page 291