Figure 3 - 4. Stroke Select Key Switch - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
Stroke Select Key Switch
SmartPAC 2
POWER
BRAKE
WARNING
SINGLE
STROKE
INCH CONT
OFF
Use the Stroke Select key switch to select OFF, INCH, SINGLE STROKE or CONT
(continuous) mode of press operation. You can set the key switch to the desired operating
mode and then remove the key to prevent anyone from changing the operating mode.
When the Lockout message appears on the display, clear it by turning the Stroke Select key
switch to OFF and then back to the desired operating mode.
DANGER
!
PRESS NOT PROPERLY GUARDED FOR CONTINUOUS OPERATION
Disconnect the "continuous mode" position of your stroke select switch and cover the
"CONT" label on your control if the press is not properly guarded for use in continuous mode.
See
Failure to comply with these instructions will result in death or serious injury.
SmartPAC 2 Keyboard, Displays
and Operating Modes
F1
CAMBIE
AL ESPANOL
F2
F3
F4
F5
F6
F7
F8
1 2 3
PROG RUN
ENTER
4 5 6
HELP
7 8 9
RESET
0 .
CLEAR

Figure 3 - 4. Stroke Select Key Switch

Chapter 3
1126800
Stroke Select
key switch
SINGLE
STROKE
INCH CONT
OFF
Page 175