Set Other Channels For The Tool; Delete Channel Settings - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
2. Use the up an down cursor keys to set the number of seconds for "Off Delay Time." The
maximum is 254 seconds. You can have the output follow the resolver motion by
pressing the down cursor key when the value on the screen is zero (0).
3. Press RESET when you are done.

Set Other Channels for the Tool

When you are done setting a channel, make settings for the rest of your channels.
1. Choose the next channel from the list of channel names. Make settings for that channel.
2. Make settings for all your other channels.
3. When you are done with all channels, display the list of channels. Then press RESET.
You will return to the display allowing you the choice of setting counters, cams or batch
mode. You can perform other tasks. If you press RESET again, you will return to the
first display in Program mode.
NOTICE
SmartPAC 2 saves your settings automatically. You do not have to press any key or issue
any command to save settings.

Delete Channel Settings

To delete settings for a cam channel, select the cam channel, then select "Delete channel
settings" from the next display. The settings for the channel will go back to 0° on—0° off (or
0° On—0° time on for timed settings). You will automatically go back to the list of cam
channels.
SmartPAC 2 Program Mode
Figure 5 - 37. Set DSV ON Delay Time
Chapter 5
1126800
page 313