Tool Information - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration

TOOL INFORMATION

(PROGRAM – TOOL INFORMATION)
NOTICE
• Tool Information serves only as a convenient place to record information about the tool. It
does not control any aspect of press operation.
• This feature is not available if you have the optional PLC interface installed.
Select "Tool Information" under the main Programming menu (Figure 5 - 3) to record useful
information about the tool you are programming. See "Tool number information" in
Chapters 4 to set up the information items.
If this display appears, you need to enter the general password to access these settings. Password
access is set under Security Access in Initialization mode. See
page 251
.
You will see a display similar to the following:
Use cursor
keys to
move
selection
bar to
desired
item. Press
ENTER.
Figure 5 - 39. Tool Number Information Screen
SmartPAC 2 Program Mode
ENTER YOUR PASSWORD
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSON KEYS TO
INCREASE/DECREASE. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
TOOL NUMBER INFORMATION
PASS LINE HT
STRAIGHTENER
HYD. OVLD.
PRESS SPEED
CONVEYOR
PART LUBE
MEMO BOX
CAREFULLY CHECK
DIE PLACEMENT
USE CURSOR KEYS TO CHOOSE THE VALUE YOU
WANT TO CHANGE. PRESS THE ENTER KEY TO
CHANGE IT. PRESS RESET KEY WHEN DONE.
Chapter 5
60599
"Security Access" in Chapter 4,
IN
4.50
4.25 IN
100 TONS
65 SPM
NO
YES
MEMO LINE 1
MEMO LINE 2
1126800
F4
F5
page 315