Additional Security - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration

Additional Security

You can secure your WPC adjustments by installing a user-supplied keylock switch. For
installation instructions, see page 66, "Wire a Keylock Switch to Prevent changes to WPC
Settings." The switch works as follows:
• Switch CLOSED (grounded): prevents changes to any WPC settings in Program and
Run modes
• Switch OPEN (not grounded): Normal operation of Program and Run modes.
By using this keylock switch, you can prevent anyone from making changes to WPC settings
in Program mode and Run mode. This keylock switch overrides the Security Access settings
discussed in the previous sections.
Here are the messages that you will see in SmartPAC's Program and Run modes when the
keylock switch is closed at input 1.
PRESS CONTROL PARAMETERS
TOP STOP ANGLE
MAX. PRESS SPEED
MIN. PRESS SPEED
CNTR BAL SETPOINT
THE PRESS CONTROL EDIT MODE IS LOCKED.
PRESS THE RESET KEY WHEN DONE.
TOOL NUMBER 1234567
CHAIR BRACKET
SENSORS ENABLED
TOP STOP ANGLE
MAX. PRESS SPEED
MIN. PRESS SPEED
COUNTER. BAL
MAIN AIR
THE PRESS CONTROL EDIT MODE IS LOCKED.
PRESS THE RESET KEY WHEN DONE.
Figure 4 - 38. Press Control Adjustments Locked
SmartPAC 2 Initialization Mode
270
270
DEGREES
200
SPM
150
SPM
40
PSI
PRESS CONTROL ADJUST MENU
270
270
200
150
SETPOINT PRESSURE (PSI)
40
60
Chapter 4
message indicating
PART CNTR 0
TWO HAND INCH
DEGREES
SPM
SPM
36
65
1126800
selected operating
mode is locked
page 257