Honeywell SmartPAC 2 User Manual page 140

1126800
NOTICE
• If you turn the Prog/Run key and nothing happens, press RESET repeatedly until the
SmartPAC 2 changes modes.
• If "PRESS CONTROL IS IN LOCKOUT MODE" appears on the display, turn the stroke
select key to OFF and then back to the desired operating mode to clear the message.
Go to "Install Overrun Sensor Magnet," page 125.
Page 118
SmartPAC 2 with WPC Integration
Chapter 2 Installing SmartPAC 2 and WPC