Using The Wpc Input Status Display - Honeywell SmartPAC 2 User Manual

1126800

Using the WPC Input Status Display

[INITIALIZATION – PRESS CONTROL – INPUT STATUS]
As an aid to installation and troubleshooting, you can read the status of the inputs on the
screen of your SmartPAC. Access this information from Initialization mode by following the
steps below.
NOTICE
The LED indicators inside the housing also show the status of these inputs. See the figures
at the end of Chapter 4.
1. Enter the Initialization mode as described in Chapter 4. The Main Initialization menu
appears.
2. Select "Press Control." The WPC Initialization menu, next figure, appears.
USE THE CURSOR KEYS
TO SELECT THE ITEM
YOU WISH TO SEE.
PRESS ENTER TO
ACCESS IT. PRESS
RESET WHEN DONE.
3. Select "Input Status." The WPC Input Status display, Figure 7 - 11, appears. Select the
type of input you want to see.
Press F2 for "Buttons/Switches." See Figure 7 - 12.
Press F3 for "Estops/Top Stops." See Figure 7 - 13.
Press F4 for "Interlocks." See Figure 7 - 14.
Page 420
WPC INITIALIZATION MENU
Figure 7 - 10. WPC Initialization menu
Chapter 7
SmartPAC 2 with WPC Integration
USER INTERLOCKS
USER INTERLOCKS
PRESS PARAMETERS
PRESS OPTIONS
INPUT STATUS
SmartPAC 2 Fault Messages