Set Clock; Update Firmware - Honeywell SmartPAC 2 User Manual

1126800

SET CLOCK

(INITIALIZATION – DIAGNOSTICS – SET CLOCK)
In this screen you can set the month, day, year and time. The date is month/day/year
(mm/dd/yy). The time is based on 24 hours, so 1:30 p.m. is 13:30 and 11:00 p.m. is 23:00
1. Use the left and right cursor keys to highlight the part of the date and time that you want
to change. Press ENTER. A number entry box appears.
2. Use the number keys or the up and down cursors to place the number you want in the
entry box.
3. Press ENTER when done; press RESET to cancel and close the box. To stop the clock,
press F1. To start it again, press F1 again.
NOTICE
You will have to change the clock setting when your local time changes from Standard to
Daylight Savings time in the spring and from Daylight Savings to Standard time in the fall.

UPDATE FIRMWARE

(INITIALIZATION – DIAGNOSTICS – UPDATE FIRMWARE)
To update the firmware in your SmartPAC 2, go to "Appendix C – Update SmartPAC 2
Firmware," page 453.
Page 266
Figure 4 - 45. Clock Setting Screen
Chapter 4
SmartPAC 2 with WPC Integration
F1
F2
F3
F4
F5
F6
F7
F8
SmartPAC 2 Initialization Mode