Settings Locked In Run Mode, Or Password Required; Smartpac 2 With Wpc Integration - Honeywell SmartPAC 2 User Manual

1126800
If this happens, turn the Program/Run key to "program." Press RESET to clear the error
message. Then load a tool number (see "LOAD NEW TOOL," page 357). Now set the
Program/Run key to "Run." SmartPAC 2 will go into Run mode.
Settings Locked in Run Mode, or Password
Required
SmartPAC 2's security access feature can lock settings in run mode, or require a password
for settings to be changed if you have the password option. Whenever settings are locked in
Run mode, you will see a message on the screen telling you so when you select the item. If a
password is required, enter it at the screen overlay that appears, below.
If this display appears, you need to enter the general password to access these settings. Password
access is set under Security Access in Initialization mode. See "Security Access" in Chapter 4,
page 251.
Figure 6 - 4. "Enter Your Password" Display
If settings are locked in Run mode, you can display the information, but nothing happens if
you try to make an adjustment. "Adjust mode locked" means you cannot adjust settings. If
counters are locked, you cannot change the current count. If cam settings are locked, a
message appears on the screen that reads, "CAM ADJUSTMENT IS LOCKED OUT.
PRESS RESET WHEN DONE." The item "Load new tool" does not appear on the Run
menu at all if "Load New Tool" is locked in Run Mode.
For more detail, see "Security Access" in Chapter 4, page 251.
For HELP press the HELP key located at the center of the cursor (arrow) keys.
Page 326
ENTER YOUR PASSWORD
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSON KEYS TO
INCREASE/DECREASE. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
Chapter 6

SmartPAC 2 with WPC Integration

60599
SmartPAC 2 Run Mode