Smartpac 2 With Wpc Integration - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration

USE THE CURSOR KEYS
TO SELECT THE ITEM
YOU WISH TO SEE.
PRESS ENTER TO
ACCESS IT. PRESS
RESET WHEN DONE.
3. Select "Press Parameters." The Press Control Parameter menu appears (next figure). Use
the cursor keys to highlight "Stop Limit" in the display shown below. Then press
ENTER to select.
USE THE CURSOR KEYS TO CHOOSE THE VALUE
YOU WANT TO CHANGE.
PRESS THE ENTER KEY TO CHANGE THE VALUE.
PRESS THE RESET KEY WHEN DONE.
Figure 4 - 29. "Press Parameters" Display in SmartPAC's Initialization Mode
4. The bar highlights the Stop Time Limit value. To change this value, press ENTER. Now
the message at the bottom of the display reads
5. Use the number keys to change the Stop Time Limit. Press ENTER to accept the change.
Use the cursor key to select the Start Time Limit value. Do as you did in step 2 for start
time limit. Press RESET when done. The WPC Initialization menu appears.
6. Select "Press Control." The WPC Initialization menu appears. Select "Press Options."
In the menu that appears, set Switch 7 to CLOSED to disable changes (see page 247).
SmartPAC 2 Initialization Mode
WPC INITIALIZATION MENU
Figure 4 - 28. WPC Initialization Menu
PRESS CONTROL PARAMETER MENU
TOP STOP DEFLT
CARRYUP ANGLE
MICRO TIME
MICRO ANGLE
MAIN AIR LIMIT
CNTR BAL +/-
STOP LIMIT
START LIMIT
SHUT DOWN LIMIT
FLYWHEEL TIMER
ACTS ANGLE
INITIALIZE PARAMETERS
Chapter 4
USER INTERLOCKS USER INTERLOCKS
PRESS PARAMETERS
PRESS OPTIONS
INPUT STATUS
=
220 DEG
=
149 DEG
=
100 MSEC
=
185 DEG
=
0 PSI
=
0 PSI
=
250
250 MSEC
=
199 MSEC
=
5 MIN
=
6 SEC
=
0 DEG
1126800
page 233