Smartview Function; Setup E-Mail - Honeywell SmartPAC 2 User Manual

1126800

SMARTVIEW FUNCTION

(INITIALIZATION – SETUP NETWORK)
NOTICE
• Consult with your network administrator when setting up SmartView.
This function affects SmartPAC 2's operation with SmartView remote viewing utility. (See
"Appendix D – SmartView," page 455.)
• If you will use SmartView, set this to ENABLED.
• If you will not use SmartView, set this to DISABLED.
Highlight the item next to "SMARTVIEW." Press ENTER to toggle between ENABLED
and DISABLED. When the correct choice is showing, press RESET.

SETUP E-MAIL

(INITIALIZATION – SETUP NETWORK – SETUP E-MAIL)
NOTICE
• Consult with your network administrator when setting up e-mail.
• Use SmartView remote viewing utility (See "Appendix D – SmartView," page 455) to set up
e-mail messages and recipients.
If you will use SmartPAC 2 to send e-mail, select SETUP E-MAIL. In the screen that
appears (Figure 4 - 41, above) fill in the items as described below. Table 4 - 14, below,
explains what each item is and gives examples of how to fill it in. For assistance, ask the
person in your plant who supports the computer network.
Page 260
Figure 4 - 41. Setup Email Screen
Chapter 4
SmartPAC 2 with WPC Integration
F1
F2
F3
F4
F5
F6
F7
F8
SmartPAC 2 Initialization Mode