Setup Network; E-Mail Function - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration

SETUP NETWORK

(INITIALIZATION – SETUP NETWORK)
NOTICE
• Your network administrator must connect SmartPAC 2 to your computer network before you
can use e-mail messaging or SmartView remote viewing utility. For e-mail, your network
must have a valid SMTP mail server.
• If your network requires static IP addresses, your network administrator should contact
Wintriss Tech Support; see "CHANGE NETWORK SETTINGS," page 262.
This menu contains items relating to connection to your computer network, setting up e-mail
and using SmartView remote viewing utility (see "Appendix D – SmartView," page 455).

E-MAIL FUNCTION

(INITIALIZATION – SETUP NETWORK)
NOTICE
• Consult with your network administrator when setting up e-mail.
• Use SmartView remote viewing utility (See "Appendix D – SmartView," page 455) to set up
e-mail messages and recipients.
If you want to use SmartPAC 2's e-mail function, enable it here.
• If you will use SmartPAC 2 to send e-mail, set this to ENABLED.
• If you will not use SmartPAC 2 to send e-mail, set this to DISABLED.
Highlight the item next to "E-MAIL FUNCTION." Press ENTER to toggle between
ENABLED and DISABLED. When the correct choice is showing, press RESET.
SmartPAC 2 Initialization Mode
Figure 4 - 40. Network Setup Menu
Chapter 4
1126800
page 259