Honeywell SmartPAC 2 User Manual page 3

DANGER
!
IMPROPER INSTALLATION, USE OR MAINTENANCE
• Ensure that the machinery complies with OSHA regulations 1910.217 and ANSI B11.1-2001.
• Follow all procedures in this manual. Perform only the tests and repairs listed in this manual. Use only factory-supplied
replacement parts. Ensure that all safety procedures are followed during installation and operation of WPC.
• Wire and install WPC and other equipment according to the requirements of OSHA 1910.147 Control of Hazardous
Energy (Lockout/ Tagout).
• Lockout/Tagout the press during all installation, modification, repair or maintenance procedures.
• Ensure that the dual safety valve used on the press complies with OSHA 1910.217 (b) (7) (xi). Contact manufacturer to
verify compliance of your model.
• Ensure that any foot control complies with OSHA 1910.217 (b) (7) (x).
• Ensure that WPC clutch/brake control is installed, tested and repaired by qualified personnel.
• Wire, install and maintain WPC clutch/brake control in accordance with the applicable safety standards. Carry out all
inspection procedures in OSHA 1910.217
• Install and maintain your machine guarding system according to OSHA standard 1910.217, ANSI B11.1, ANSI B11.19
and any other regulations and standards that apply. Ensure that guarding is properly installed to prevent access to the
machine over, under or around any guarding device.
• Perform all installation verification and checkout tests after installation and after any modification or repair of the WPC
clutch/brake control. Correct any problems before using the press.
• Maintain all presses as stated in the applicable regulations. Honeywell takes no responsibility in cases where stopping
mechanisms of machinery or other devices are not maintained or do not meet the applicable regulations or standards.
• Ensure that supervisors, die-setters, maintenance persons, machine operators, foremen, and any others responsible
for operation of the machinery have read and understood all instructions for use of the WPC clutch/brake control.
• DO NOT use touch buttons for any safeguarding use.
Failure to comply with these instructions will result in death or serious injury.
x
WARNING
!
MACHINERY NOT CONFIGURED OR WORKING PROPERLY
• Ensure that the press on which WPC clutch/brake control is used meets the machine guarding requirements of OSHA
standard 1910.217 and any other regulations and standards that apply.
• DO NOT operate a press equipped with WPC clutch/brake control if the machine or any of its stopping mechanisms is
not in proper working order.
Failure to comply with these instructions could result in death or serious injury.
WARNING
!
OTHER EQUIPMENT CONTINUING TO OPERATE
• Ensure that all operators and other affected personnel know which equipment may continue to operate and which will
not. Equipment that operates with the machinery connected to WPC clutch/brake control may continue to operate after
the press has received a stop signal.
Failure to comply with these instructions could result in death or serious injury.
WARNING
!
ELECTRIC SHOCK HAZARD
• Turn off and disconnect power from WPC clutch/brake control, the press and any other machinery it is
connected to before making any wiring connections. This includes power to the press's motor.
Failure to comply with these instructions could result in death or serious injury.
The enforcement of the above requirements is beyond Honeywell's ability to control. For proper WPC operation, it
is your responsibility to follow these requirements and any other requirements that may be specific to your
machinery.