Honeywell SmartPAC 2 User Manual page 490

1126800
stop types
stopping angle
stopping time
strokes counter
suppressor
timing
tool name
tool number
Tool Template
top stop
top stop constant
total hits counter
USB
page 468
ability to set the way the control stops the press for a
malfunction
crankshaft rotation angle that it takes for the press to stop;
stopping position in degrees minus the crankshaft position when
the dual safety valve (DSV) is closed; useful when setting up die
protection system
how long it takes the crankshaft to stop moving after the Dual
Safety Valve (DSV) deactivates
increments each press cycle
reduces or eliminates electrical noise
"ON" and "OFF" settings for sensors and/or cam channels
alpha-numeric designation linked to the tool number which aids
in easier identification
a numeric value assigned to keep track of all settings made
a tool on the Tool Manager list that you can use to make
repetitive tool programming easier. Program the Tool Template
with the programming items that are the same on several tools.
Then use the Tool Template as the basis for programming new
tools. Any tool that you name "Tool Template" will serve as the
template.
signal which allows the press to stop at top of stroke (0°); used
when an emergency-stop setting might cause the press to stick
on bottom, and when one hit after a malfunction will not damage
the die or press
used to accommodate a press automation function at WPC;
feature that works best on presses that have speed ranges of
several hundred to over a thousand strokes per minute (see
Chapter 4)
increments all hits on a tool; if the tool number is loaded again
after other tools are used, the counter starts counting from the
last recorded number for the previous job; useful for deciding
when a tool needs regrinding
stands for Universal Serial Bus, a computer term. SmartPAC 2
has a USB connector at J117 on the PC board. You can plug in
a mouse, keyboard or "USB disk" to perform different functions.
SmartPAC 2 with WPC Integration
Glossary