SmartPAC 2 with WPC Integration
SmartPAC 2's Three Modes of Operation
You can do various things with SmartPAC 2 depending on the mode you are in.
•
Initialization Mode. Used to make settings that generally only need to be made once
after installation. You can set cam names and lock out certain setting parameters.
Initialization mode is discussed in detail in Chapter 4.
•
Program mode. Used to make your sensor and cam timing, counter, and other settings
(if installed) for your tools. You cannot use this mode while the press is running. You
can load settings for a tool in this mode. The displays you see in Program mode are
described in Chapter 5.
•
Run Mode. You must be in Run mode to operate the press. You can adjust timing for
your sensors and cam channels (if installed) while the press is running. You see
actuation angles for green sensors. You can also load tool settings in Run mode. The
settings you can make in Run mode are explained in Chapter 6.
Introduction to SmartPAC 2
Chapter 1
1126800
page 19