System Components - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
Keyboard
Cursor keys
Number keys
Function keys
HELP key
ENTER key
RESET key

System Components

• Resolver, which provides WPC with accurate crank angle position information at every
point in the stroke
• Operator Station from which the press is run. The Operator Station available from
Wintriss Controls has several switches and indicator lights located on the front or sides of
the unit.
• Two RUN/INCH palm switches, used to initiate press action.
• PRIOR ACT switch, used as an arming switch that, in certain operating modes, must
be pressed before the press will initiate a stroke.
• PALM TIME LED, which illuminates when any one palm button is pressed. To run
the press, the other palm button must be pressed before the light goes out.
• EMERGENCY STOP / RESET switch, which can be used to immediately stop the
press. Either this switch or the RESET key on SmartPAC 2 resets WPC when a fault
condition occurs.
• MUTE LED, which illuminates when the light curtain is muted during the up stroke
(requires optional firmware).
Introduction to SmartPAC 2
Consists of various keys and a numeric keypad described
below. You use these keys along with the display to make
settings.
Enable you to move the highlight bar over the item on the
display you want to select; also used to select alphabetic
characters and special symbols when naming the press, tools,
cam channels, and sensors
Enable you to input numeric values, such as counter presets or
tool numbers
Periodically used to perform certain tasks in SmartPAC 2. The
message on the display will identify the specific function key
number to depress (from F1 to F8). These are also used as
"Hot keys," which take the user directly to the desired screens.
Enables you to see a help screen about the display you are
looking at.
Causes the SmartPAC 2 to accept the menu selection you have
made or the number you have keyed in.
Tells SmartPAC 2 you are done with a programming or other
procedure. Also resets SmartPAC 2 after fault or event
messages appear on the display.
Chapter 1
1126800
page 5