Verify Proper Installation Of Procampac And/Or Dipropac Options - Honeywell SmartPAC 2 User Manual

1126800
Verify Proper Installation of ProCamPAC and/or
DiProPAC Options
If you installed ProCamPAC and/or DiProPAC into SmartPAC 2, you need to verify that the
installation was done correctly and that these options appear on the screen.
To do this, highlight "Installed Options" on the Initialization menu (see page 189 to enter
Initialization mode). Press ENTER. The list of Installed options appears. Check to see that
the options you installed are on the list, "ProCamPAC" and/or "DiProPAC."
• If the appropriate option or options are on the list, go to the next section.
• If you do not see the appropriate option on the list, go to "Adding or Upgrading
ProCamPAC or DiProPAC," page 80, and verify that you proceeded with the
installation properly. Check that the option board or boards are plugged into the
correct connectors. If you still cannot fix the problem, contact Wintriss Tech
Support.
Page 100
Figure 2 - 30. List of Installed Options
Chapter 2
SmartPAC 2 with WPC Integration
Installing SmartPAC 2 and WPC