Figure 4 - 31. "Micro-Inch" Display - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
However, no matter how long you hold the buttons, the clutch is engaged only for the Micro-
inch time you set. You can stop the ram before the set time by releasing the switches. To jog
the ram through a complete stroke, press and release the RUN/INCH switches as many times
as necessary.
Micro-inch Angle is the crank-angle position at which you want Micro-inch operate when it
is enabled. The Micro-inch Angle can be set at any angle. A setting of 185° (default value)
will result in turning OFF (disabling) Micro-inch. Conversely, a setting of 186° will turn
Micro-inch ON all the time.
Examples
If you set the Micro-inch Angle to 300°, the press will Micro-inch from 300° to 185°. Normal
inching resumes from 185° to 300°.
If you set the Micro-inch Angle to 186°, the press will automatically Micro-inch throughout the
stroke, from 186° to 185°.
1. If you are not already there, get into SmartPAC's Initialization mode (Figure 4-1), and
select "Press Control." In the WPC Initialization menu that appears, select "Press
Parameters." Use the cursor keys to first highlight "Micro Time" in this display. Then
press ENTER to select.
USE THE CURSOR KEYS TO CHOOSE THE VALUE
YOU WANT TO CHANGE.
PRESS THE ENTER KEY TO CHANGE THE VALUE.
PRESS THE RESET KEY WHEN DONE.
2. Use the number keys to make your selection, and then press ENTER.
3. Use the cursor keys to select "Micro Angle," and repeat step 2. Press RESET when done.
SmartPAC 2 Initialization Mode
PRESS CONTROL PARAMETER MENU
TOP STOP DEFLT
CARRYUP ANGLE
MICRO TIME
MICRO ANGLE
MAIN AIR LIMIT
CNTR BAL +/-
STOP LIMIT
START LIMIT
SHUT DOWN LIMIT
FLYWHEEL TIMER
ACTS ANGLE
INITIALIZE PARAMETERS

Figure 4 - 31. "Micro-Inch" Display

Chapter 4
=
220 DEG
=
149 DEG
=
100 100 MSEC
=
185 DEG
=
0 PSI
=
0 PSI
=
250 MSEC
=
199 MSEC
=
5 MIN
=
6 SEC
=
0 DEG
1126800
page 237