Honeywell SmartPAC 2 User Manual page 485

SmartPAC 2 with WPC Integration User Manual
cursor keys
depth penetration factor
display
dual diverse redundancy
Dual Safety Valve
dwell duration time
emergency stop
enable mode
ENTER key
fault (error) message
flywheel timer
function keys
good parts counter
Glossary
used to move the selection bar over the item on the display to be
selected; also used to make certain programming and adjusting
entries, and to select alphabetic characters and special symbols
when naming the press, tools, cam channels, and sensors
measurement of how far an object, like an operator's hand, can
move through the light curtain before the light curtain reacts
the screen on the SmartPAC 2 that displays text and graphics,
used along with the keyboard to make and adjust settings, to
load tool numbers, and to view diagnostic messages
the latest technology in maintaining optimum clutch/brake
control and operator safety, where both of the micro-processor
systems ("dual micro-processors") function independently of
each other, have separate power supplies, and provide separate
information to the operator
controls the air flow that operates the clutch and brake of the
press
how long the cam channel and/or sensor are expected to stay
activated
signal sent to the press as soon as a malfunction occurs; should
be used when the operator wants the press to stop immediately
ability to activate or deactivate sensors connected to the die
protection mode; see also manual enable; auto enable by tool;
and auto enable by sensor
used after highlighting a selection or keying in a value on the
display
diagnostics that indicate why the press was stopped, identify the
problem, and suggest how to correct
proper setting of this WPC feature prohibits starting the motor in
the reverse direction or activating the Bar mode while the
flywheel is still turning
periodically used to perform certain tasks in SmartPAC; the
message on the LCD display will identify the specific function
key number to depress (from F1 to F8)
increments only "good" parts if the die protection and/or tonnage
monitoring option does not generate a fault
1126800
page 463