Honeywell SmartPAC 2 User Manual page 119

SmartPAC 2 with WPC Integration
NOTICE
• If the Prog/Run key is set to Run, "PRESS CONTROL IS IN LOCKOUT MODE" appears on
the display. To clear, turn the stroke select key to OFF and then back to the desired
operating mode.
• If another error message appears when SmartPAC 2 starts up, press RESET.
• If the message still appears, find the error message in Chapter 7 and follow the instructions
for correcting the problem. If you cannot find the error message, or you cannot fix the
problem, contact Wintriss Tech Support.
4. Press and hold down both the "1" and "CLEAR" keys at the same time for one second.
The Initialization menu appears, similar to the next figure.
Figure 2 - 29. SmartPAC 2 Main Initialization Menu
Installing SmartPAC 2 and WPC
Figure 2 - 28. Main Program Menu
Chapter 2
1126800
page 97