Operating The Press Using One-Hand Control - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
You must have the right firmware in your SmartPAC 2/WPC to use One-hand Control in
"light curtain break" mode. If you are unsure of what you have, contact Wintriss Tech
Support.
One-hand Control will work with or without the "light curtain break" option switch set to
OPEN (see "Switch 3 – One-hand Control or Foot Switch Mode," page 243). If "light curtain
break" is enabled, you must press the One-hand Control button within eight seconds after
removing your hand from the light curtain; otherwise, the press will not start. If the "light
curtain break" mode is not enabled, whenever you press the One-hand Control button, the
press will start.

Operating the Press Using One-hand Control

Follow these steps to operate the press using One-hand Control:
1. Set option switch 3 to the appropriate setting, depending upon whether you want to use
"light curtain break" mode. See information about "light curtain break" mode, page 378,
and the instructions for setting option switch 3, page 243.
• If you want to use "light curtain break" mode, set Switch 3 to CLOSED.
• If you do not want to use "light curtain break" mode, set Switch 3 to OPEN.
2. Set the Stroke Select Switch to SINGLE STROKE.
3. If an Interrupted Stroke message flashes on the display, make one stroke by pressing and
holding down the dual run buttons. This clears the interrupted stroke mode.
4. Start the press as follows:
• If you are using One-hand Control without "light curtain break," just push the One-
hand Control switch button. The press will run and stop at the top of the stroke.
• If you are using "light curtain break," start the press by first breaking the light curtain
and removing your hands, then pushing the button on the One-hand Control within
eight seconds. The press will make one stroke and stop at the top of the stroke.
NOTICE
The PRIOR ACT LED illuminates after the light curtain has been interrupted, and stays on
for the time set. If the One-hand Control button is not pushed within the set time, the PRIOR
ACT LED will turn off. The press will not start until you break the light curtain again and then
push the One-hand Control button within eight seconds.
NOTICE
If the press does not run, turn off power to the press and WPC. Recheck all wiring and
connections. Try One-hand Control again. If the press still does not run, contact Wintriss
Tech Support.
SmartPAC 2 Run Mode Chapter 6
1126800
page 379