Figure B - 16. Shows "Slide Adjust Motor" In "Alert" Mode - Honeywell SmartPAC 2 User Manual

1126800
YOUR PRESS NAME
THERE IS 1 ITEM WITH ALERT STATUS
SLIDE ADJ. MOTOR
CHECK AT
CURRENT
CLUTCH VALVE
CHECK AT
CURRENT
GIBS
CHECK AT
CURRENT
MORE
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE

Figure B - 16. Shows "Slide Adjust Motor" in "Alert" Mode

4. To view other items in the schedule that may or may not be in "alert" status, use the
cursor keys. If more than three PM items were set in Initialization, they will not all
appear on the screen. To view them, simply use the cursor keys to scroll down the list.
5. To clear the alert, first highlight that item, press the appropriate function key (designated
on your screen), and enter the PM password.
NOTICE
When you clear the alert condition for a certain item, you automatically reset its current value
to zero. You cannot recall the previous value.
6. If you want to change the frequency value on a given PM item, first highlight that item,
press the designated function key, and enter the PM password. The number display will
be superimposed over the screen (similar to Figure A-11). Use the number keys or
cursor keys to modify the tracking frequency for that PM item.
7. After you are done viewing or modifying this screen, press RESET to return to the main
Run menu.
page 452
PM MONITOR
!! ALERT!!
100 DIE CHANGES
101 DIE CHANGES
2000 STARTS/STOPS
1055 STARTS/STOPS
CHANGE
1000000 STROKES
558836 STROKES
Appendix B
SmartPAC 2 with WPC Integration
shows how many alert
alert conditions are
current
PM Monitor alerts
you to check specific
item in "alert" status mode.
CLEAR
F3
Notice "!!ALERT!!"
ALERT
flashes.
F4
VALUE
SmartPAC Preventive Maintenance
(PM) Monitor