Honeywell SmartPAC 2 User Manual page 124

1126800
USE THE CURSOR KEYS
TO SELECT THE ITEM
YOU WISH TO SEE.
PRESS ENTER TO
ACCESS IT. PRESS
RESET WHEN DONE.
2. Select PRESS PARAMETERS. You will see a screen similar to the following.
USE THE CURSOR KEYS TO CHOOSE THE VALUE
YOU WANT TO CHANGE.
PRESS THE ENTER KEY TO CHANGE THE VALUE.
PRESS THE RESET KEY WHEN DONE.
Figure 2 - 32. "Press Parameters" Display in SmartPAC's Initialization Mode
3. Select INITIALIZE PARAMETERS. The following warning message appears:
Figure 2 - 33. Initialize Parameters Warning Message
Page 102
WPC INITIALIZATION MENU
Figure 2 - 31. WPC Initialization Menu
PRESS CONTROL PARAMETER MENU
TOP STOP DEFLT
CARRYUP ANGLE
MICRO TIME
MICRO ANGLE
MAIN AIR LIMIT
CNTR BAL +/-
STOP LIMIT
START LIMIT
SHUT DOWN LIMIT
FLYWHEEL TIMER
ACTS ANGLE
INITIALIZE PARAMETERS
IF YOU CONTINUE THIS WILL INITIALIZE
ALL OF THE PRESS CONTROL PARAMETERS.
THESE INCLUDE THE BRAKE MONITOR
SETTINGS AND TOP STOP ANGLE.
PRESS THE ENTER KEY TO CONTINUE.
PRESS RESET TO CANCEL.
Chapter 2
SmartPAC 2 with WPC Integration
USER INTERLOCKS USER INTERLOCKS
PRESS PARAMETERS
PRESS OPTIONS
INPUT STATUS
=
220 DEG
=
149 DEG
=
100 MSEC
=
185 DEG
=
0 PSI
=
0 PSI
=
250 250 MSEC
=
199 MSEC
=
5 MIN
=
6 SEC
=
0 DEG
Installing SmartPAC 2 and WPC