Using A Customized Web Authentication Login Page From An External Web Server - Cisco 2100 Series Configuration Manual

Choosing the Web Authentication Login Page
These are the available status codes:
•
•
•
•
•
For additional information, refer to the External Web Authentication with Wireless LAN Controllers
Note
Configuration Example at this URL:
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008067489
f.shtml
Using a Customized Web Authentication Login Page from an External Web
Server
If you want to use a customized web authentication login page that you configured on an external web
server, follow the instructions in the GUI or CLI procedure below. When you enable this feature, the user
is directed to your customized login page on the external web server.
You must configure a preauthentication access control list (ACL) on the WLAN for the external web
Note
server and then choose this ACL as the WLAN preauthentication ACL under Security Policies > Web
Policy on the WLANs > Edit page. See
Using the GUI to Choose a Customized Web Authentication Login Page from an External Web Server
Click Security > Web Auth > Web Login Page to open the Web Login page (see
Step 1
Figure 10-12
Cisco Wireless LAN Controller Configuration Guide
10-16
Status Code 1: "You are already logged in. No further action is required on your part."
Status Code 2: "You are not configured to authenticate against web portal. No further action is
required on your part."
Status Code 3: "The username specified cannot be used at this time. Perhaps the username is already
logged into the system?"
Status Code 4: "You have been excluded."
Status Code 5: "The User Name and Password combination you have entered is invalid. Please try
again."
Web Login Page
Chapter 5 for more information on ACLs.
Chapter 10 Managing User Accounts
Figure 10-12).
OL-17037-01