Cisco 2100 Series Configuration Manual page 184

Configuring and Viewing Location Settings
To see the status of active Network Mobility Services Protocol (NMSP) connections, enter this
6.
command:
show nmsp status
Information similar to the following appears:
LocServer IP
-------------- ----------- ---------
171.71.132.158
To see the NMSP counters, enter this command:
7.
show nmsp statistics {summary | connection all}
where
–
–
Information similar to the following appears for the show nmsp statistics summary command:
NMSP Global Counters
Client Measure Send Fail:
Send RSSI with no entry:
Send too big msg:
Failed SSL write:
Partial SSL write:
SSL write attempts to want write:
Transmit Q full:
Max Measure Notify Msg:
Max Info Notify Msg:
Max Tx Q Size:
Max Rx Size:
Max Info Notify Q Size:
Max Client Info Notify Delay:
Max Rogue AP Info Notify Delay:
Max Rogue Client Info Notify Delay:
Max Client Measure Notify Delay:
Max Tag Measure Notify Delay:
Max Rogue AP Measure Notify Delay:
Max Rogue Client Measure Notify Delay:0
Max Client Stats Notify Delay:
Max Tag Stats Notify Delay:
RFID Measurement Periodic:
RFID Measurement Immediate:
Reconnect Before Conn Timeout:
Information similar to the following appears for each active connection when you enter the show
nmsp statistics connection all command:
NMSP Connection Counters
Connection 1:
Cisco Wireless LAN Controller Configuration Guide
4-88
TxEchoResp RxEchoReq
21642
summary shows the common NMSP counters, and
connection all shows the connection-specific NMSP counters.
Connection status: UP
Freed Connection: 0
Nmsp Subscr Req: 0
Info Req: 1
Measure Req: 2
Stats Req: 2
Info Notify: 0
Loc Capability: 2
Location Req: 0
Chapter 4 Configuring Controller SettingsWireless Device Access
TxData RxData
------- -------
21642 51278 21253
0
0
0
0
0
0
0
0
2
1
0
0
0
0
0
0
0
0
0
0
0
0
NMSP Subscr Resp:
Info Resp:
Measure Resp:
Stats Resp:
Measure Notify:
Location Rsp:
0
1
2
2
0
0
OL-17037-01