Cisco 2100 Series Configuration Manual page 530

Transferring Files to and from a Controller
Figure 9-6
From the File Type drop-down box, choose Configuration.
Step 2
If the configuration file is encrypted, check the Configuration File Encryption check box and enter the
Step 3
encryption key used to decrypt the file in the Encryption Key field.
Note
From the Transfer Mode drop-down box, choose TFTP or FTP.
Step 4
In the IP Address field, enter the IP address of the TFTP or FTP server.
Step 5
If you are using a TFTP server, the default values of 10 retries and 6 seconds for the Maximum Retries
Step 6
and Timeout fields should work correctly without any adjustment. However, you can change these
values. To do so, enter the maximum number of times that the TFTP server attempts to download the
configuration file in the Maximum Retries field and the amount of time (in seconds) that the TFTP server
attempts to download the configuration file in the Timeout field.
Step 7 In the File Path field, enter the directory path of the configuration file.
Step 8 In the File Name field, enter the name of the configuration file.
If you are using an FTP server, follow these steps:
Step 9
In the Server Login Username field, enter the username to log into the FTP server.
a.
In the Server Login Password field, enter the password to log into the FTP server.
b.
In the Server Port Number field, enter the port number on the FTP server through which the
c.
download occurs. The default value is 21.
Click Download to download the file to the controller. A message appears indicating the status of the
Step 10
download, and the controller reboots automatically. If the download fails, repeat this procedure and try
again.
Cisco Wireless LAN Controller Configuration Guide
9-24
Download File to Controller Page
The key that you enter here should match the one entered during the upload process.
Chapter 9 Managing Controller Software and Configurations
OL-17037-01