Using The Cli To Configure Access Control Lists - Cisco 2100 Series Configuration Manual

Chapter 5 Configuring Security Solutions
Check the Web Policy check box.
Step 4
From the Preauthentication ACL drop-down box, choose the desired ACL and click Apply. None is the
Step 5
default value.
Note
Click Save Configuration to save your changes.
Step 6

Using the CLI to Configure Access Control Lists

Follow these steps to configure ACLs using the controller CLI.
To see all of the ACLs that are configured on the controller, enter this command:
Step 1
show acl summary
Information similar to the following appears:
ACL Counter Status
-------------------------------------
ACL Name
------------------------- -----------
acl1
acl2
acl3
To see detailed information for a particular ACL, enter this command:
Step 2
show acl detailed acl_name
Information similar to the following appears:
I Dir IP Address/Netmask IP Address/Netmask Prot
- --- ------------------ ------------------ ---- ----------- -------- ----- ------ -------
1 Any 0.0.0.0/0.0.0.0
2 In
DenyCounter :
The Counter field increments each time a packet matches an ACL rule, and the DenyCounter field
increments each time a packet does not match any of the rules.
To enable or disable ACL counters for your controller, enter this command:
Step 3
config acl counter {start | stop}
Note
OL-17037-01
See Chapter 6 for more information on configuring WLANs.
Enabled
Applied
Yes
Source Destination
0.0.0.0/0.0.0.0
0.0.0.0/0.0.0.0 200.200.200.0/
255.255.255.0
0
If you want to clear the current counters for an ACL, enter this command:
clear acl counters acl_name
Yes
Yes
Source Port Dest Port
Any 0-65535
6 80-80
Cisco Wireless LAN Controller Configuration Guide
Configuring and Applying Access Control Lists
Range Range DSCP Action Counter
0-65535 0 Deny
0-65535 Any Permit
0
0
5-63