Cisco 2100 Series Configuration Manual page 73

Chapter 3 Configuring Ports and Interfaces
Figure 3-7
Configure the following parameters:
Step 5
Guest LAN, if applicable
•
• Quarantine and quarantine VLAN ID, if applicable
Note
Physical port assignment
•
VLAN identifier
•
Fixed IP address, IP netmask, and default gateway
•
Primary and secondary DHCP servers
•
Access control list (ACL) name, if required
•
Note
Note
Click Save Configuration to save your changes.
Step 6
Repeat this procedure for each dynamic interface that you want to create or edit.
Step 7
OL-17037-01
Interfaces > Edit Page
Check the Quarantine check box if you want to configure this VLAN as unhealthy or you
want to configure network access control (NAC) out-of-band integration. Doing so causes
the data traffic of any client that is assigned to this VLAN to pass through the controller. See
Chapter 6 for more information about NAC out-of-band integration.
See Chapter 5 for more information on ACLs.
To ensure proper operation, you must set the Port Number and Primary DHCP Server
parameters.
Configuring Dynamic Interfaces
Cisco Wireless LAN Controller Configuration Guide
3-17