Cisco 2100 Series Configuration Manual page 470

Adding Mesh Access Points to the Mesh Network
Table 8-4
Parameter
VLAN Transparent
Security Mode
Cisco Wireless LAN Controller Configuration Guide
8-18
Global Mesh Parameters (continued)
Chapter 8 Controlling Mesh Access Points
Description
This feature determines how a mesh access point
handles VLAN tags for Ethernet bridged traffic.
Refer to the "Configuring Ethernet
Note
Bridging and Ethernet VLAN Tagging"
section on page 8-25
additional configuration details.
If this parameter is enabled, then VLAN tags are
not handled and packets are bridged as if they are
untagged.
If this parameter is disabled, all packets are
tagged non-VLAN transparent or VLAN-opaque
and all tagged packets are dropped.
Uncheck the check box to enable the VLAN
Tagging feature.
VLAN Transparent is enabled as a default
Note
to ensure a smooth software upgrade from
4.1.192.xxM releases to release 5.2.
Release 4.1.192.xxM does not support
VLAN tagging.
Note Refer to "Configuring Ethernet Bridging
and Ethernet VLAN Tagging" section on
page 8-25 for more details.
Default: Enabled.
Defines the security mode for mesh access points:
Pre-Shared Key (PSK) or Extensible
Authentication Protocol (EAP).
EAP must be selected if external MAC
Note
filter authorization using a RADIUS
server is configured.
Local EAP or PSK authentication is
Note
performed within the controller if the
External MAC Filter Authorization
parameter is disabled (check box
unchecked).
Options: PSK or EAP
Default: EAP
for overview and
OL-17037-01