Chapter 12
Configuring Mobility GroupsWireless Device Access
To test the mobility EoIP data packet communication between two controllers, enter this command:
2.
eping mobility_peer_IP_address
The mobility_peer_IP_address parameter must be the IP address of a controller that belongs to the
mobility list.
To troubleshoot your controller for mobility ping, enter these commands:
3.
config logging buffered debugging
show logging
To troubleshoot your controller for mobility ping over UDP, enter this command to display the
mobility control packet:
debug mobility handoff enable
Note
OL-17037-01
Cisco recommends using an ethereal trace capture when troubleshooting.
Cisco Wireless LAN Controller Configuration Guide
Running Mobility Ping Tests
12-29