Using The Cli To Configure 802.3 Bridging - Cisco 2100 Series Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access
Figure 4-9
Step 2 From the 802.3 Bridging drop-down box, choose Enabled to enable 802.3 bridging on your controller
or Disabled to disable this feature. The default value is Disabled.
Note
Click Apply to commit your changes.
Step 3
Step 4 Click Save Configuration to save your changes.

Using the CLI to Configure 802.3 Bridging

Follow these steps to configure 802.3 bridging using the controller CLI.
To see the current status of 802.3 bridging for all WLANs, enter this command:
Step 1
show network
To enable or disable 802.3 bridging globally on all WLANs, enter this command:
Step 2
config network 802.3-bridging {enable | disable}
The default value is disabled.
Note
OL-17037-01
General Page
In controller software release 5.2, you can disable 802.3 bridging only for 4400 series
controllers, the Cisco WiSM, and the Catalyst 3750G Wireless LAN Controller Switch.
In controller software release 5.2, you can disable 802.3 bridging only for 4400 series
controllers, the Cisco WiSM, and the Catalyst 3750G Wireless LAN Controller Switch.
Cisco Wireless LAN Controller Configuration Guide
Configuring 802.3 Bridging
4-33