Cisco 2100 Series Configuration Manual page 357

Chapter 6 Configuring WLANsWireless Device Access
To add an access point to this access point group, check the check box to the left of the access point name
Step 16
and click Add APs. The access point now appears in the list of access points currently in this access
point group.
Note
Note
Note
Step 17 Click Save Configuration to save your changes.
Using the CLI to Create Access Point Groups
Using the controller CLI, follow these steps to create access point groups.
Step 1 To create an access point group, enter this command:
config wlan apgroup add group_name
Note
To add a description to an access point group, enter this command:
Step 2
config wlan apgroup description group_name description
Step 3 To assign a WLAN to an access point group, enter this command:
config wlan apgroup interface-mapping add group_name wlan_id interface_name
Note
Step 4 To enable or disable NAC out-of-band support for this access point group, enter this command:
config wlan apgroup nac {enable | disable} group_name wlan_id
OL-17037-01
To select all of the available access points at once, check the AP Name check box. All of the
access points are then selected.
If you ever want to remove an access point from the group, check the check box to the left of the
access point name and click Remove APs. To select all of the access points at once, check the
AP Name check box. All of the access points are then removed from this group.
If you ever want to change the access point group to which an access point belongs, click
Wireless > Access Points > All APs > ap_name > Advanced tab, choose the name of another
access point group from the AP Group Name drop-down box, and click Apply.
To delete an access point group, enter this command: config wlan apgroup delete group_name.
A warning message appears if you try to delete an access point group that is used by at least one
access point. If you proceed, any access points assigned to this access point group are moved to
the default-group access point group.
To remove a WLAN from an access point group, enter this command: config wlan apgroup
interface-mapping delete group_name wlan_id.
Cisco Wireless LAN Controller Configuration Guide
Configuring WLANs
6-47